Hello,
I am working on a .Net 4.0 web application which uses Crystal Reports 13 (CRVS 2010). Actually this has been migrated from .Net 1.1 which was using Crystal Reports 11. Now one of my requirement is to generate few reports in which paging is disabled (of course when exported to PDF it does come out in multiple pages) such that the entire report content is shown in a single view on the web page (with a vertical scroll bar). Now to achieve this I set a few properties as shown below -
- Set DisplayToolbar to false on the crystal report viewer control
- Set the SeparatePages property to false on crystal report viewer control
- In the report (rpt file) I enabled/set Keep Together on all sections and also set Suppress Blank Section property
- As I did not have much in page footer I set the Reserve Minimum Page footer property. I also set Clamp Page footer property
However when my report is displayed in the page, I observe blank lines in between the content (shown in the attached jpeg). A deeper look suggests that these blanks appear right at the point where I would have had the page break if I had enabled paging. This makes my report look odd on the web page. With the old application which used previous version of CR this was not the case. Is there a way wherein I can ensure that the report when displayed on the web page concatenates the content properly without any gaps considering that I disabled paging?
Any help would be highly appreciated.
Thanks,
GowriShanker.
P. S: Also attached is the report file with extension changed to txt.
