Hi,
I am using Crystal Reports 2011 with SP9 installed. My report is a main report with 56 subreports and during the creation of the report and running it through the IDE the report runs in less than 20 seconds. When I run this same report through a .Net executable the report takes about 14 minutes to finish.
I have built in some logging functionality into the .Net executable and have the issue pinned down to when I am applying the table.ApplyLogOnInfo. The function that iterates over all the subreports and tables in each subreport takes 13 minutes from start to finish.
I have found other discussion on the boards here to look at virus software, firewalls and certificate revocation lists. I have tried implementing these and it hasn't offered any type of boost in performance.
Here is the function that applies the db logon information. Any insight or ideas will be greatly appreciated.
Thank You,
Jim